Table of Contents
Advertisement
To raise the machine, move both cutting height levers forward;
to lower the machine, move them rearward (Figure 13).
1. Raising the machine
Note: The cutting height settings are as follows: A = 21
mm; B = 33 mm; C = 50 mm; D = 67 mm; E = 84 mm;
and F = 98 mm.
Adjusting the Upper Handle
Height
You may raise or lower the upper handle to a position
comfortable for you.
Note: You cannot raise the upper handle higher than the
angle of the lower handle.
1. Loosen the upper handle knob (Figure 14).
Figure 13
2. Lowering the machine
G020355
Figure 14
2. Move the upper handle to the desired position
(Figure 15).
3. Tighten the upper handle knob firmly (Figure 16).
G020273
Starting the Engine
1. Hold the blade control bar (Figure 17) against the
handle.
1. Blade control bar
2. Turn the ignition key (Figure 18) or pull the recoil start
handle (Figure 19).
9
G020274
Figure 15
G020354
Figure 16
1
G020368
Figure 17
Advertisement
Table of Contents
