Adjusting The Upper Handle Height; Starting The Engine - Toro 20952 Operator's Manual

To raise the machine, move both cutting height levers forward;
to lower the machine, move them rearward
1. Raising the machine
Note: The cutting height settings are as follows: A = 21
mm; B = 33 mm; C = 50 mm; D = 67 mm; E = 84 mm;
and F = 98 mm.
Adjusting the Upper Handle
Height
You may raise or lower the upper handle to a position
comfortable for you.
Note: You cannot raise the upper handle higher than the
angle of the lower handle.
1. Loosen the upper handle knob
(Figure
Figure 13
2. Lowering the machine
(Figure 14).
G020355
Figure 14
2. Move the upper handle to the desired position
13). 15).
3. Tighten the upper handle knob firmly
G020273

Starting the Engine

1. Hold the blade control bar
handle.
1. Blade control bar
2. Turn the ignition key
handle
11
Figure 15
Figure 16
(Figure
1
Figure 17
(Figure 18) or pull the recoil start
(Figure 19).
(Figure
G020274
(Figure 16).
G020354
17) against the
G020368