Table of Contents
Advertisement
Setup
Important: Remove and discard the protective plastic
sheet that covers the engine.
1
Attaching the Handle
No Parts Required
Procedure
WARNING
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Remove the handle knobs from the machine housing
(Figure 3).
Important: Route the cables to the outside of the
handle as you install the handle.
1. Handle knob (2)
2. Move the handle to the operating position.
3. Install and tighten the handle knobs that you removed
in step 1 (Figure 3).
4. Move the upper handle to the desired position and
tighten the upper handle knob firmly (Figure 4).
1
G020270
Figure 3
2
Assembling the Grass Bag
No Parts Required
Procedure
1. Slide the bag over the wire frame as shown in Figure 5.
2. Snap the clips onto the wire frame as shown in Figure 6.
5
G020354
Figure 4
Figure 5
Advertisement
Table of Contents
