Setup; Installing The Upper Handle; Installing The Wheel-Clutch-Cable Ends - Toro Power Max 1028 Operator's Manual

Setup

1

Installing the Upper Handle

No Parts Required
Procedure
2
Installing the
Wheel-Clutch-Cable Ends
No Parts Required
Procedure
1. Unwrap and discard the bubble wrap from the
cables on the lower handle
2. Route either the left or right cable end over the
lower handle and insert the cable end into the
(Figure 5).
Figure 5
hole in the corresponding wheel-clutch lever
(Figure 6).
1. Wheel-clutch lever
3. Remove the nut and washer from the handle,
attach the cable clamp on the cable to the
handle, install the washer and the nut, and
tighten the nut by hand
g001302
5
Figure 6
(Figure 7).
g293415
g001303