Setup; Installing The Upper Handle - Toro 37779 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
8
1

Installing the Upper Handle

Parts needed for this procedure:
2 Handle bolts
2 Curved washers
2 Locknuts
Procedure
1. Lift and rotate the upper handle and position it over
the lower handle (Figure
2. Install 2 handle bolts, 2 curved washers, and 2 locknuts
in the lower handle holes
Description
Handle bolts
Curved washers
Locknuts
Hairpin cotter
Flat washer
Nut
Carriage bolt
Flat washer
Carriage bolts
Locknuts
No parts required
No parts required
No parts required
No parts required
3).
(Figure 3).
Qty.
2
2 Install the upper handle.
2
2
Install the traction control linkage.
3
2
2 Install the chute.
2
2
Install the chute control rod.
2
–
Check the engine oil level.
–
Check the tire pressure.
–
Check the skids and scraper.
–
Check the operation of the traction drive.
6
Use
g019003
Figure 3