Cropping A Scan - Fuel3D SCANIFY F3D2001 User Manual

Cropping a scan

Cropping allows you to place points on your scan to select the area you wish to keep or
remove.
You can place a point by clicking a position on your scan. This creates a node. At least three
nodes are required to create an area that can then be accepted as a crop, however it is
recommended to select more depending on what you are cropping.
Remove all cropzones
Erase node mode
List of crop zones
The more node points you have the less sharp the edges of the scan will appear; this is
helpful when cropping something round, such as a face, as it allows you to keep the shape
of the face.
33
Select the cropping button to open the crop interface
Redo
Undo
Cancel cropping mode,
discard changes
Delete crop zone
Confirm selected crop
Cropping a scan
Create a new
crop zone