Cropping A Scan - Fuel3D SCANIFY F3D2001 User Manual

Cropping a scan

Cropping allows you to place points on your scan to select the area you wish to keep.
You can place a point by clicking a position on your scan. This creates a node. At least three
nodes are required to create an area that can then be accepted as a crop but it is
recommended to select more depending on what you are cropping.
The more node points you have the less sharp the edges of the scan will appear; this is
helpful when cropping something round, such as a face, as this helps to keep the shape of
the face.
19
Select the cropping button to open the crop interface
Cropping a scan
Confirm the crop you have selected
Undo or redo your previous node selection
Select to erase nodes you have placed
Add a negative crop inside a current crop area
Add an additional crop outside of the current
crop area