Fuel3D SCANIFY F3D2001 User Manual page 42

Good data
Remove all cropzones
Erase node mode
List of crop zones
You can place a point by clicking a position on your scan. This creates a node. At least three
nodes are required to create an area that can then be accepted as a crop but it is
recommended to select more depending on what you are cropping.
The more node points you have, the less sharp the edges of the scan will appear; this
is helpful when cropping something round, such as a face to help keep the shape of
the face.
When stitching multiple scans together there needs to be a minimum of 25% overlap
between scans. This is to ensure you get a successful alignment.
41
Redo
Undo
Remove the data that
looks pulled and
stretched.
Cancel cropping mode,
discard changes
Delete crop zone
Create a new
crop zone
Confirm selected crop