Headlight Switch - Toro 03780 Operator's Manual

unit blades. Push in the button to disengage the cutting unit
blades.
2
1
3
4
5
6
1. Lower mow/raise control
lever
2. Key switch
3. InfoCenter
Engine Speed Switch
The engine speed switch (Figure 27) has two modes to
change the engine speed. By momentarily tapping the switch,
the engine speed can be increased or decreased in 100 rpm
increments. By holding the switch down the engine will
automatically move to High or Low idle, depending on which
end of the switch is depressed.

Headlight Switch

Pivot the switch downward to turn on the headlights (Figure
27).
Power Point
The power point (Figure 28) is used to power optional 12
volt electrical accessories.
Figure 27
4. PTO switch
5. Engine speed switch
6. Headlight switch
G021208
1. Power point
Bag Holder
Use the bag holder (Figure 28) for storage.
Backlap Levers
Use the backlap levers for backlapping the reels (Figure 29).
1. Front backlap lever
23
Figure 28
2. Bag holder
Figure 29
2. Rear backlap lever