Toro 03780 Operator's Manual page 25

InfoCenter Icon Description
SERVICE DUE Indicates when scheduled service
should be performed
Engine RPM/status—indicates the
engine RPM
Info icon
Fast
Slow
Fan Reversal—indicates when the
fan is reversed
Stationary regeneration required
Air intake heater is active
Raise cutting units
Lower cutting units
Operator must sit in seat
Parking Brake Indicator—indicates
when the parking brake is On
Identifies the range as High
Neutral
Identifies the range as Low
Coolant Temperature-indicates the
engine coolant temperature in either
°C or °F
Temperature (hot)
Denied or not allowed
PTO is engaged
Engine Start
InfoCenter Icon Description (cont'd.)
/
Symbols are often
combined to form
sentences. Some
examples are shown
below
25
Stop or shutdown
Engine
Key switch
Indicates when the cutting units are
being lowered
Indicates when the cutting units are
being raised
PIN passcode
Hydraulic Oil Temperature-indicates
the hydraulic oil temperature
CAN bus
InfoCenter
Bad or failed
Bulb
Output of TEC controller or control
wire in harness
High: over allowed range
Low: under allowed range
Out of range
Switch
Operator must release switch
Operator should change to indicated
state
Operator should put machine in
neutral
Engine start denied
Engine shutdown
Engine coolant too hot