Setting The Mowing Height; Replacing The Mowing Blades; Changing The Motor Oil - Fieldmann FZR 4611 B User Manual

SETTING THE MOWING HEIGHT

The mowing height is set centrally using the central mowing height adjustment lever (Fig. 1 – point 10)
You can select from 5 positions in the range of 25 to 75 mm. The middle mowing height is the most suitable for
the majority of lawns.
Lawn damage may result when the lowest height is set.

REPLACING THE MOWING BLADES

Caution! For this task, we recommend that you contact an authorised service centre.
Caution! Prior to removing the blade, drain the oil from the oil tank.
If you wish to replace the mowing blade, remove the bolt (Fig. 7). Perform the installation according to the
provided picture. Tighten the screw. The tightening torque is 40 Nm. When replacing the the blade, replace the
fastening bolt also.

CHANGING THE MOTOR OIL

Caution! For this task, we recommend that you contact an authorised service centre.
The drain plug is located under the engine
(Fig. 8 – point 1). Place a suitable container for
catching the used oil under the engine and remove the
plug. Tilt the lawnmower so that all the oil can drain
from the oil tank.
After draining the oil, put the plug back into the hole,
making sure that the plug is securely in its place and
wipe away any drops of spilled oil.
Add type SAE30 or 15W-40 oil into the oil tank.
When the oil dipstick is inserted into the hole and
screwed in, the oil level should be between the Min and
Max marks (Fig. 8). Do not overfi ll the oil tank.
Start the engine and allow it to run for a short time.
Stop the engine, wait 1 minute and remeasure the
oil level in the oil tank. Add oil to the required level if
necessary.
PETROL LAWNMOWER
Controlling and operating the lawnmower 11
Fig. 7
Fig. 8
USER'S MANUAL
EN