Cleaning; Cleaning Under The Mower; Waste Disposal; Storage - Toro GrandStand 74534 Operator's Manual

Cleaning

Cleaning Under the Mower

Service Interval: Before each use or daily
Remove the grass buildup under the mower daily.
1. Disengage the PTO, move the motion control levers to
the neutral locked position and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Raise the front of the machine and use jack stands to
support the mower.

Waste Disposal

Engine oil, batteries, hydraulic oil, and engine coolant are
pollutants to the environment. Dispose of these according to
your state and local regulations.

Storage

Cleaning and Storage

1. Disengage the power take off (PTO), set the parking
brake, and turn the ignition key to off. Remove the key.
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially the
engine. Clean dirt and chaff from the outside of the
engine's cylinder head fins and blower housing.
Important: You can wash the machine with mild
detergent and water. Do not pressure wash the
machine. Avoid excessive use of water, especially
near the drive system and engine. Pressure
washing can force dirt and water into critical parts,
such as spindle bearings and electrical switches.
3. Check the brake; refer to Servicing the Brake in
Brake Maintenance (page 41).
4. Service the air cleaner; refer to Servicing the Air
Cleaner in Engine Maintenance (page 30).
5. Grease the machine; refer to Greasing and Lubrication
in Lubrication (page 28).
6. Change the engine oil; refer to Servicing the Engine in
Engine Maintenance (page 30).
7. Check the tire pressure; refer to Checking the Tire
Pressure in Drive System Maintenance (page 37).
8. For long-term storage:
A. Add stabilizer/conditioner additive to fuel in the
tank.
B. Run engine to distribute conditioned fuel through
the fuel system (5 minutes).
C. Stop engine, allow to cool and drain the fuel
tank; refer to Servicing the Fuel Tank in
Fuel System Maintenance (page 34), or operate
engine until it stops.
D. Restart engine and run until it stops. Repeat, on
Choke until engine will not restart.
E. Dispose of fuel properly. Recycle as per local
codes.
Note: Do not store stabilizer/conditioned
gasoline over 90 days.
9. Remove the spark plug(s) and check its
condition; refer to Servicing the Spark Plug in
Engine Maintenance (page 30). With the spark plug(s)
removed from the engine, pour two tablespoons of
engine oil into the spark plug hole. Now use the starter
to crank the engine and distribute the oil inside the
cylinder. Install the spark plug(s). Do not install the
wire on the spark plug(s).
10. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged or defective.
55