1
2
1. On
Operating the Ignition Switch
1. Turn the ignition key to the Start position (Figure 13).
When the engines starts, release the key.
Important: Do not engage starter for more than 5
seconds at a time. If the engine fails to start allow
a 15 second cool-down period between attempts.
Failure to follow these instructions can burn out
the starter motor.
Note: Additional starting cycles may be required
when starting the engine for the first time after the fuel
system has been without fuel completely.
2. Turn the ignition key to the stop position to stop the
engine.
Using the Fuel Shut-Off Valve
The fuel shut-off valve is located behind the right side of the
operator cushion.
G008959
Figure 12
2. Off
G008947
Figure 13
Close the fuel shut-off valve for transport, maintenance, and
storage (Figure 14).
Ensure the fuel shut-off valve is open when starting the
engine.
1
2
G008948
1. On
Starting and Stopping the
Engine
Starting the Engine
1. Connect the wires to the spark plugs.
2. Open the fuel valve.
3. Move the right motion control lever to neutral locked
position.
4. Set the parking brake; refer to Setting the Parking
Brake.
5. Move the blade control switch (PTO) to the Off
position.
6. Move the throttle lever midway between the Slow and
Fast positions.
Note: A warm or hot engine may not require choking.
16
g020864
Figure 14
2. Off