Motion Control Levers - Toro GrandStand 74534 Operator's Manual

3
G012705
1. Switch (on front side)
2. 3 mm (1/8 inch)
12. Tighten the switch screws.
Adjusting the Neutral Position for the

Motion Control Levers

Important: Ensure the tracking of the mower is correct
after adjusting the motion control levers. Adjusting the
tracking and aligning the motion control levers front to
back is the same procedure (Figure 69).
Note: Adjust the horizontal alignment before the front to
back alignment.
If the motion control levers do not align front to back, or the
right side control lever does not move easily into the neutral
lock position, adjustment is required.
1. After the horizontal alignment is finished, check the
front to back alignment by slightly pushing the control
levers forward to take up any slack in the linkage for
the control levers (Figure 69).
1 2
2
Figure 68
3. Right motion control lever
in the neutral unlocked
position
1
1. Left motion control lever
2. Right motion control lever
2. Ensure the right motion control lever moves easily into
the neutral lock position.
Note: Turn the cable adjustment clockwise to move
the motion control handle forward. Turn the cable
adjustment counter-clockwise to move the motion
control handle rearward.
3. Rotate the cable adjustment on right side when
adjustment is needed. Adjust the cable adjustment in
quarter-turn increments.
4. After the right motion control lever moves easily into
the neutral lock position, adjust the left motion control
lever to align with the right motion control lever.
5. Check for proper tracking. Refer to
Adjusting the Tracking (page 37).
1. Left cable adjustment
2. Right cable adjustment
45
2
G012706
Figure 69
3. Neutral locked position
4. Align the control levers
front to back
Figure 70
3. Platform down
3
4