Controls System Maintenance; Adjusting The Motion Control Handle Positions - Toro GrandStand 74534 Operator's Manual

Controls System
Maintenance
Adjusting the Motion Control
Handle Positions
Adjusting the Right Side Motion Control
Lever
If the motion control levers do not align horizontally, adjust
the right side motion control lever.
Note: Adjust the horizontal alignment before the front to
back alignment.
1. Disengage the PTO, move the right side motion control
lever to the neutral position and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Push the right motion control lever down out of locked
neutral position (Figure 66).
4. Check if it aligns horizontally with the left motion
control lever (Figure 66).
Figure 66
1. Left motion control lever
2. Right motion control lever
in neutral locked position
5. To adjust the right motion control lever horizontally,
the cam needs to be adjusted.
6. Remove the cushion from the rear of the machine.
7. Loosen the nut holding the cam (Figure 67).
8. Adjust the cam until the right motion control lever
aligns with the left motion control lever and tighten the
nut and bolt for the cam.
3. Check the horizontal
alignment here
4. Right motion control lever
G012704
1. Switch screws
2. Cam
9. After the cam is adjusted, the lever switch needs to be
checked.
10. Check the gap between the control lever and switch
as shown in Figure 68. The gap needs to be an 3 mm
(1/8 inch) with the right motion control lever in the
neutral, unlocked position.
11. If needed, loosen the screws holding the switch and
adjust the switch (Figure 67 and Figure 68).
44
1
Figure 67
3. Nut
2
3