Table of Contents
Advertisement
6
5
4
3
2
1
1. Throttle control
2. Enable/disable switch
3. Glow plug indicator light
4. Engine coolant
temperature warning
light
5. Diagnostic light
Key Switch
The key switch (Figure 7) has three positions: Off,
On/Preheat, and Start.
Engine Coolant Temperature Warning
Light
This light (Figure 7) illuminates and the mowers shut down
when the engine coolant reaches a high temperature. If the
engine temperature continues to rise, the engine will shut
down.
Engine Coolant Temperature Gauge
During normal operating conditions the gauge (Figure 7)
should be in the green range. Check the cooling system if the
gauge goes to the yellow or red range.
Diagnostic Light
It will illuminate should a system fault be recognized.
Lower Mow/Raise Control Lever
This lever (Figure 7) raises and lowers the cutting decks
and also starts and stops the mowers when the mowers are
enabled in the mow mode.
7
8
9
G003956
Figure 7
6. Engine coolant
temperature gauge
7. Engine oil pressure
warning light
8. Charge indicator
9. Key switch
10. Lower mow/raise control
lever
Glow Plug Indicator Light
This light (Figure 7) illuminates when the glow plugs are
preheating.
10
Engine Oil Pressure Warning Light
This light (Figure 7) indicates dangerously low engine oil
pressure.
Charge Indicator
The charge indicator (Figure 7) illuminates when the system
charging circuit malfunctions.
Enable/Disable Switch
Use the enable/disable switch (Figure 7) in conjunction with
the lower mow/raise control lever to operate the mowers.
The mowers cannot be lowered when the mow/transport
lever is in the transport position.
Hour Meter
The hour meter (Figure 8) shows the total hours that the
machine has been operated.
1. Hour meter
Hydraulic Filter Restriction Indicator
With the engine running at normal operating temperature,
view the indicator (Figure 9), it should be in the Green zone.
When the indicator is in the Red zone, change the hydraulic
filters.
15
Figure 8
Advertisement
Table of Contents
