Table of Contents
Advertisement
Figure 39
1. Water separator filter canister
3. Clean the area where the filter canister mounts.
4. Remove the filter canister and clean the mounting
surface.
5. Lubricate the gasket on the filter canister with clean oil.
6. Install the filter canister by hand until the gasket
contacts mounting surface, then rotate it an additional
1/2 turn.
7. Tighten the drain plug on the bottom of the filter
canister.
Fuel Pick-up Tube Screen
The fuel pick-up tube, located inside the fuel tank, is equipped
with a screen to help prevent debris from entering the fuel
system. Remove the fuel pick-up tube and clean screen as
required.
Bleeding Air from the Fuel
Injectors
Note: This procedure should be used only if the fuel system
has been purged of air through normal priming procedures
and the engine will not start; refer to Bleeding the Fuel
System.
1. Loosen the pipe connection to the No. 1 nozzle and
holder assembly (Figure 40).
1. Fuel injectors
2. Turn the key in the key switch to the On position and
watch the fuel flow around the connector. When you
observe a solid flow of fuel, turn the key to the Off
position.
3. Tighten the pipe connector securely.
4. Repeat the procedure on the remaining nozzles.
33
Figure 40
Advertisement
Table of Contents
