1. Traction manifold
2. Spacers
3. Bolts
4. Washers
•
Remove the 3 bolts, washers, and spacers securing the traction manifold to the bottom of the rear bumper (Figure 4a).
•
Position the appropriate amount of weight on the top and/or bottom of the rear bumper.
•
Mount the weight(s) and the traction manifold to the bumper with the 3 bolts, washers and spacers previously removed
(Figure 4b).
Note: Do not use the spacers when installing more than two weights under the bumper (Figure 4c).
•
Secure the outer edges of the weight(s) to the bumper with 2 carriage bolts and nuts (Figure 4c).
Figure 4
5. Weight(s)
6. Carriage bolt
7. Nut
13