Cleaning; Cleaning Under The Front Of The Machine; Washing The Underside Of The Mower - Toro 74785 Operator's Manual

9. Secure the rear end of the rod into the mower with a
nut (3/8 inch) as shown in
Important: The grass deflector must be spring
loaded and in the down position. Lift the deflector
up to test that it snaps to the full down position.
Figure 56.

Cleaning

Cleaning Under the Front of
the Machine
Service Interval: After each use—Check and clean the front
of the mower.
Remove debris under the front of the machine with
compressed air or by hand with a brush
Note: Do not use water to clean under the front of the
machine, this can cause build up of debris.
Washing the Underside of the
Mower
Service Interval: After each use—Clean the mower housing.
Important: You can wash the machine with a mild
detergent and water. Do not pressure wash the machine.
Avoid excessive use of water, especially near the control
panel, under the seat, around the engine, hydraulic
pumps, and motors.
Wash the underside of the mower after each use to prevent
grass buildup for improved mulch action and clipping
dispersal.
1. Park the machine on a level surface and disengage the
blade control switch.
2. Ensure the parking brake is engaged, stop the engine,
remove the key, and wait for all moving parts to stop
before leaving the operating position.
3. Attach the hose coupling to the end of the mower
washout fitting, and turn the water on high
Note: Spread petroleum jelly on the washout fitting
O-ring to make the coupling slide on easier and protect
the O-ring.
41
(Figure 57).
Figure 57
(Figure 58).