1. Positive battery post
2. Negative battery post
Installing the Battery
1. Position the battery in the tray
2. Install the positive (red) battery cable to the positive (+)
battery terminal using the fasteners removed previously.
3. Install the negative battery cable to the negative (-)
battery terminal using the fasteners removed previously.
4. Slide the red terminal boot onto the positive (red)
battery post.
5. Secure the battery with the hold-down
6. Lower the seat.
Figure 37
3. Red (+) charger lead
4. Black (-) charger lead
(Figure
36).
(Figure
Servicing the Fuses
The electrical system is protected by fuses. It requires
no maintenance; however, if a fuse blows, check the
component/circuit for a malfunction or short.
Fuse:
•
Main F1-30 amp, blade-type
•
Charge Circuit F2-25 amp, blade-type
1. Remove the screws securing the control panel to the
machine. Retain all fasteners
2. Lift the control pane up to access the main wiring
harness and fuse block
3. To replace a fuse, pull out on the fuse to remove it
(Figure
36).
1. Main-30 amp
4. Return the control panel to its original position. Use
the screws removed previously to secure the panel to
the machine.
33
(Figure
38).
38).
1
2
Figure 38
2. Charge circuit-25 amp
G014540