Side-Discharging The Clippings - Toro Super Recycler 20797 Operator's Manual

Figure 26
1. Rear-discharge deflector
Important: Ensure that the rear-discharge plug is
locked in place. To lock the plug, firmly push the
plug in until it snaps into place behind the tabs,
and rotate the lever on the plug to the left
27).
Figure 27
1. Lever
2. Rear-discharge plug
(Figure
2. Tabs
Note: To unlock the plug, rotate the lever on the plug
to the right (Figure
5. Lower the rear-discharge deflector.
Side-Discharging the
Clippings
Use the side discharge for cutting very tall grass.
If the bag is on the machine, remove it and insert the
rear-discharge plug; refer to
13) before side-discharging the clippings.
Important: Ensure that the rear-discharge plug
is locked in place. To lock the plug: Raise the
rear-discharge deflector
plug in until it snaps into place behind the tabs, and
rotate the lever on the plug to the left
1. Discharge deflector
Note: To unlock the plug, rotate the lever on the plug to the
right (Figure 27).
WARNING
The blade is sharp; contacting the blade can result
in serious personal injury.
Stop the engine and wait for all moving parts to stop
before leaving the operating position.
Installing the Side-Discharge Chute
1. Unlock the side-discharge door
2. Lift open the side-discharge door
14
27).
Removing the Grass Bag (page
(Figure 28), firmly push the
(Figure 27).
Figure 28
2. Rear-discharge plug
(Figure 29).
Figure 29
(Figure 30).