Setup; Assembling And Unfolding The Handle - Toro Super Recycler 20797 Operator's Manual

Setup

Important: Remove and discard the protective plastic
sheet that covers the engine.
1
Assembling and Unfolding the
Handle
No Parts Required
Procedure
WARNING
Assembling and unfolding the handle improperly
can damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when assembling and
unfolding the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Raise the rear of the machine housing to its
highest cutting-height setting by moving the 2 rear
cutting-height levers all the way forward. Refer to
Adjusting the Cutting Height (page
2. Attach the handle ends to the machine housing with
2 washers and 2 handle bolts
tighten the handle bolts.
1. Washer
2. Handle bolt
3. Rotate the handle rearward
10).
(Figure 3), but do not
Figure 3
3. Handle end
(Figure 4).
4. Lock the handle at your desired height; refer to
Adjusting the Handle Height (page
5. Torque the handle bolts to 120 to 160 in-lb (14 to 17
N-m).
6. Adjust the cutting height; refer to
Height (page 10).
6
G020751
Figure 4
11).
Adjusting the Cutting