Toro Super Recycler 20792 Operator's Manual
Toro Super Recycler 20792 Operator's Manual

Toro Super Recycler 20792 Operator's Manual

53cm super recycler lawn mower
Hide thumbs Also See for Super Recycler 20792:

Advertisement

53cm Super Recycler® Lawn Mower
Model No. 20792—Serial No. 280000001 and Up
Introduction
Read this information carefully to learn how to operate
and maintain your product properly and to avoid injury
and product damage. You are responsible for operating
the product properly and safely.
You may contact Toro directly at www.Toro.com for
product and accessory information, help finding a
dealer, or to register your product.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model
and serial numbers of your product ready. Figure 1
identifies the location of the model and serial numbers
on the product.
Figure 1
1. Model and serial number plate
Write the product model and serial numbers in the space
below:
Model No.
Serial No.
This manual identifies potential hazards and has
safety messages identified by the safety alert symbol
(Figure 2), which signals a hazard that may cause serious
injury or death if you do not follow the recommended
precautions.
© 2008—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
1. Safety alert symbol
This manual uses 2 words to highlight information.
Important calls attention to special mechanical
information and Note emphasizes general information
worthy of special attention.
For models with stated engine horsepower, the gross
horsepower of the engine was laboratory rated by the
engine manufacturer in accordance with SAE J1940.
As configured to meet safety, emission, and operating
requirements, the actual engine horsepower on this class
of lawn mower will be significantly lower.
Safety
Improperly using or maintaining this mower can
result in injury. To reduce the potential for injury,
comply with these safety instructions.
Toro designed and tested this mower for reasonably safe
service; however, failure to comply with the following
instructions may result in personal injury.
To ensure maximum safety, best performance, and
to gain knowledge of the product, it is essential
that you and any other operator of the mower read
and understand the contents of this manual before
the engine is ever started. Pay particular attention
to the safety alert symbol (Figure 2) which means
Caution, Warning, or Danger—"personal safety
instruction." Read and understand the instruction
because it has to do with safety. Failure to comply
with the instruction may result in personal injury.

General Lawn Mower Safety

The following instructions have been adapted from the
ISO standard 5395.
This cutting machine is capable of amputating hands
and feet and throwing objects. Failure to observe the
following safety instructions could result in serious
injury or death.
Register at www.Toro.com.
Form No. 3359-347 Rev A
Operator's Manual
Figure 2
Original Instructions (EN)
Printed in the USA
All Rights Reserved

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Super Recycler 20792 and is the answer not in the manual?

Questions and answers

Summary of Contents for Toro Super Recycler 20792

  • Page 1: General Lawn Mower Safety

    Authorized Service horsepower of the engine was laboratory rated by the Dealer or Toro Customer Service and have the model engine manufacturer in accordance with SAE J1940. and serial numbers of your product ready. Figure 1...
  • Page 2 Training absolutely necessary and lift only the part, which is away from the operator. • Read the instructions carefully. Be familiar with the controls and the proper use of the equipment. • Start the engine or switch on the motor carefully according to instructions and with feet well away •...
  • Page 3: Sound Power

    • Be careful during adjustment of the lawn mower to prevent entrapment of the fingers between moving blades and fixed parts of the lawn mower. • To ensure the best performance and safety, purchase only genuine Toro replacement parts will fit and accessories. Do not use parts and accessories;...
  • Page 4: Safety And Instructional Decals

    Safety and Instructional Decals Important: Safety and instruction decals are located near areas of potential danger. Replace damaged decals. Manufacturer’s Mark 1. Indicates the blade is identified as a part from the original machine manufacturer. 112-8760 1. Thrown object hazard—stay a safe distance from the machine.
  • Page 5: Assembling And Unfolding The Handle

    Setup Important: Remove and discard the protective plastic sheet that covers the engine. 1. Assembling and Unfolding 114-7982 the Handle 1. Warning—read the 4. Cutting/dismemberment Operator’s Manual. hazard of hand or foot, mower blade—stay away Procedure from moving parts. 2. Thrown object 5.
  • Page 6: Installing The Starter Rope

    2. Installing the Starter Rope Procedure Pull the starter rope through the rope guide on the handle (Figure 5). Figure 5 1. Starter rope 2. Rope guide Note: To make the rope easier to install, squeeze the control bar on the handle. 3.
  • Page 7: Product Overview

    Product Overview Operation Filling the Fuel Tank Gasoline is extremely flammable and explosive. A fire or explosion from gasoline can burn you and others. • To prevent a static charge from igniting the gasoline, place the container and/or mower directly on the ground before filling, not in a vehicle or on an object.
  • Page 8: Checking The Engine Oil Level

    Checking the Engine Oil Level Service Interval: Before each use or daily 1. Remove the dipstick, wipe it clean, and fully install the dipstick (Figure 10). Figure 11 Figure 10 2. Remove the dipstick and check the oil level Adjusting the Handle Height (Figure 10).
  • Page 9: Recycling The Clippings

    Starting the Engine Stopping the Engine 1. Pull the blade control bar to the handle (Figure 13). Release the blade control bar (Figure 16). Important: When you release the blade control bar, the blade should stop within 3 seconds. If it does not stop properly, stop using your mower immediately and contact an Authorized Service Dealer.
  • Page 10: Bagging The Clippings

    Check the grass bag frequently. If it is damaged, install a new Toro replacement bag. Figure 20 If the side discharge chute is on the mower, remove it 1. Discharge deflector 2.
  • Page 11: Removing The Grass Bag

    Removing the Grass Bag 1. Route the starter rope around the lower rope guide (Figure 22). Figure 24 1. Tabs 5. Lower the discharge deflector. Figure 22 1. Lower rope guide Side-discharging the Clippings Use the side discharge for cutting very tall grass. Note: The lower rope guide releases the starter rope Important: Ensure that the rear discharge plug is when you pull the recoil start handle.
  • Page 12: Operating Tips

    • For best performance, install a new blade before the cutting season begins. • Replace the blade when necessary with a Toro replacement blade. Cutting Grass • Cut only about a third of the grass blade at a time.
  • Page 13: Cutting Leaves

    Cutting Leaves – Replace the blade or have it sharpened. – Walk at a slower pace while mowing. • After cutting the lawn, ensure that half of the lawn shows through the cut leaf cover. You may need to – Raise the cutting height on your mower. make more than one pass over the leaves.
  • Page 14: Preparing For Maintenance

    Preparing for Maintenance 3. Replace the air filter. 4. Install the cover (Figure 33). 1. Stop the engine and wait for all moving parts to stop. 2. Disconnect the spark plug wire from the spark plug (Figure 31) before performing any maintenance procedure.
  • Page 15: Replacing The Blade

    Replacing the Blade 4. Slowly pour oil into the oil fill tube until the oil level reaches the Full line on the dipstick (Figure 36). Do Service Interval: Every 25 hours—Replace the blade not overfill. (Max. fill: 20 oz. (0.59 l), type: SAE 30 or have it sharpened (more frequently detergent oil with an API service classification of SF, if the edge dulls quickly).
  • Page 16: Cleaning The Mower

    Important: Position the curved ends of the 4. Turn the water on. blade to point toward the mower housing. 5. Start the engine and run it until there are no more 6. Use a torque wrench to tighten the blade bolt to clippings that come out from under the mower 60 ft-lb (82 N⋅...
  • Page 17: Folding The Handle

    Folding the Handle 1. Rotate the handle forward (Figure 40). Important: Route the cables to the outside of the handle knobs as you fold the upper handle. Figure 40 2. To unfold the handle, refer to Assembling and Unfolding the Handle in the Setup section. Removing the Mower from Storage 1.
  • Page 18 Notes:...
  • Page 19 Spypros Stavrinides Limited Cyprus 357 22 434131 Surge Systems India Limited India 91 1 292299901 T-Markt Logistics Ltd Hungary 36 26 525 500 Toro Australia Australia 61 3 9580 7355 Toro Europe BVBA Belgium 32 14 562 960 374-0102 Rev B...
  • Page 20 Contact your seller to arrange service of the product. If for any reason materials or workmanship. The following time periods apply from the date it is impossible for you to contact your seller, you may contact any Toro of original purchase: Authorized Distributor to arrange service.

Table of Contents