Charging The Battery; Replacing The Fuse - Toro Super Recycler 20797 Operator's Manual

•
If the oil level is below the Add mark on the
dipstick, slowly add a small amount of oil to the
oil-fill tube, and then repeat steps
until the oil level is at the Full mark on the dipstick.
•
If the oil level is above the Full mark on the
dipstick, drain the excess oil until the oil level is at
the Full mark on the dipstick.
Important: If the oil level in the crankcase is
too low or too high and you run the engine,
you may damage the engine.
13. Install the dipstick securely.
14. Recycle the used oil at a local recycling center.

Charging the Battery

Service Interval: Every 25 hours
Before storage
Charge the battery for 24 hours initially, then monthly (every
25 starts) or as needed. Always use the charger in a sheltered
area and charge the battery at room temperature (22°C or
70°F) whenever possible.
1. Connect the charger to the machine wire harness
located below the ignition key
2. Plug the charger into a wall outlet.
Note: When the battery no longer holds a charge,
recycle or dispose of the lead-acid battery according
to local codes.
Note: Your battery charger may have a 2-color LED display
that indicates the following states of charging:
•
A red light indicates that the charger is charging the
battery.
10 through
(Figure 39).
Figure 39
•
A green light indicates that the charger is fully charged or
the charger is disconnected from the battery.
12
•
A flashing light that alternates between red and green
indicates that the battery is nearly fully charged. This state
lasts only a few minutes until the battery is fully charged.

Replacing the Fuse

If the battery does not charge or the engine does not turn
with the electric starter, the fuse may be blown. Replace it
with a 40-amp plug-in type fuse.
Important: You cannot start the machine with the
electric starter or charge the battery unless you install
the fuse.
1. Unclip both ends of the battery cover and remove it
(Figure 40).
2. Replace the fuse in the fuse holder
Note: Your machine comes with a spare fuse in the
battery compartment.
3. Install the battery cover.
18
Figure 40
(Figure 41).
Figure 41