Checking The Engine-Oil Level; Adjusting The Cutting Height - Toro Super Recycler 20797 Operator's Manual

g027380

Checking the Engine-Oil Level

Service Interval: Before each use or daily
Max. fill: 0.59 L (20 oz), type: SAE 30 detergent oil with an
API service classification of SF, SG, SH, SJ, SL, or higher.
1. Move the machine to a level surface.
2. Remove the dipstick
3. Wipe off the dipstick end with a clean cloth.
4. Insert the dipstick into the oil-fill tube and screw it in
until it stops.
5. Remove the dipstick and read the oil level; refer to
Figure 12.
•
If the oil level is below the Add mark on the
dipstick, slowly add a small amount of oil to the
oil-fill tube, and then repeat steps
the oil level is at the Full mark on the dipstick.
•
If the oil level is above the Full mark on the
dipstick, drain the excess oil until the oil level is at
the Full mark on the dipstick. To drain the excess
oil, refer to Changing the Engine Oil (page
Important: If the oil level in the crankcase is
too low or too high and you run the engine,
you may damage the engine.
6. Install the dipstick securely by hand.
1 cm (1/2 inch)
Figure 11
(Figure 12).
Figure 12
3 through

Adjusting the Cutting Height

WARNING
Adjusting the cutting height may bring you into
contact with the moving blade, causing serious
injury.
• Stop the engine and wait for all moving parts
to stop.
• Do not put your fingers under the housing when
adjusting the cutting height.
CAUTION
If the engine has been running, the muffler will be
hot and can severely burn you. Keep away from the
hot muffler.
Adjust the cutting height as desired. Set all 4 wheels to the
same height.
Note: To raise the machine, move all 4 cutting height levers
forward; to lower the machine, move them all rearward
(Figure 13).
A = 3 cm (1-1/4 inches)
B = 4 cm (1-3/4 inches)
C = 6 cm (2-1/4 inches)
D = 7 cm (2-3/4 inches)
5 until
17).
10
E = 8 cm (3-1/4 inches)
F = 1 1 cm (4-1/4 inches)
G = 1 1 cm (4-1/4 inches)
G027605
Figure 13