2. To unfold the handle, refer to
Unfolding the Handle (page
Removing the Machine from
Storage
1. Check and tighten all fasteners.
2. Remove the spark plug and spin the engine rapidly
using the starter to blow the excess oil from the
cylinder.
3. Install the spark plug and tighten it with a torque
wrench to 20 N-m (15 ft-lb).
4. Perform any needed maintenance procedures; refer to
Maintenance (page
5. Check the engine-oil level; refer to
Engine-Oil Level (page
6. Fill the fuel tank with fresh gasoline; refer to
Fuel Tank (page
9).
7. Connect the wire to the spark plug.
8. Charge the battery; refer to
18).
Figure 46
1 Assembling and
6).
16).
Checking the
10).
Charging the Battery (page
Filling the
21