Toro 41188 Operator's Manual page 60

Installing the Agitation Manifold Valve
1. Align the flange of the agitation valve manifold, 1
gasket, and the flange of the agitation bypass valve (A
of Figure 62).
Note: If needed, loosen the mounting hardware for
the master boom valve as needed to provide clearance.
Figure 62
1. Flange clamp
2. Gasket
3. Manifold (agitation valve)
4. Flange
(manifold—agitation
bypass valve)
5. Flanged-head bolt
2. Assemble the agitation bypass valve, gasket, and
agitation valve manifold with a clamp tightened hand
tight (A of Figure 62).
3. Align a 1 gasket between the flanges of the rate control
valve and the agitation valve manifold (B of
4. Assemble the rate control valve, gasket, and agitation
valve manifold with a clamp tightened hand tight ( B of
Figure 62).
5. Align a 1 gasket between the flanges of the agitation
valve manifold and the master boom valve (B of
62).
6. Valve mount
7. Flanged locknut
8. Flange (rate control valve)
9. Flange (master boom
valve)
10. Flange (adapter
fitting—agitation throttle
valve)
Figure
Figure
6. Assemble the agitation valve manifold, gasket, and
master boom valve with a clamp tightened hand tight
(B of Figure
7. Align a 1 gasket between the flanges of the agitation
valve manifold and the adapter fitting for the agitation
throttle valve (C of
8. Assemble the agitation valve manifold, gasket, and
adapter fitting with a clamp tightened hand tight (C of
Figure 62).
9. Assemble the agitation valve to the valve mount with
the flanged-head bolt and flanged locknut that you
removed in step
Valve (page 54)
1243 N-cm (90 to 110 in-lb).
10. If you loosened the mounting hardware for the master
boom valve, tighten the nut and bolt to 1978 to 2542
N-cm (175 to 225 in-lb).
62).
60
62).
Figure 62).
2 of Removing the Agitation Manifold
and torque the nut and bolt to 1017 to