Toro 41188 Operator's Manual page 20

Important: The range selector must be in the Neutral
position and the parking brake must be set for the switch
to work.
Fuel Gauge
The fuel gauge is located on top of the fuel tank, on the left
side of the machine, and shows the amount of fuel in the tank.
Master Boom Switch
The master boom switch
the console and to the right of the operator. It allows you to
start or stop the spray operation. Press the switch to enable
or disable the spray system.
Boom-Section Switches
The boom switches are located on the control panel
7). Toggle each switch forward to turn the corresponding
boom section on and rearward to turn them off. When the
switch is turned on, a light on the switch illuminates. These
switches will only affect the spray system when the master
boom switch is on.
Pump Switch
The pump switch is located on the control panel to the right
of the seat (Figure 7). Toggle this switch forward to run the
pump or rearward to stop the pump.
Important: The pump switch will only engage when the
engine is at low idle to avoid damaging the pump drive.
Application Rate Switch
The application rate switch is located on the control panel to
the right of the seat (Figure
forward to increase the spray system pressure, or press and
hold it rearward to decrease the pressure.
Supervisor (Rate Lockout) Switch
The supervisor switch is located on the control panel to the
right of the seat (Figure 7). Turn the key counterclockwise
to the locked position to disable the application rate switch,
thereby keeping anyone from accidentally changing the
application rate. Turn the key clockwise to the unlocked
position to enable the application rate switch.
Boom Lift
The boom lift switches are located on the control panel and
are used to raise the left and right boom respectively.
Hour Meter
The hour meter indicates the total number of hours the
engine has run. This number is displayed on the first screen of
(Figure 7) is located on the side of
7). Press and hold the switch
the InfoCenter. The hour meter starts to function whenever
the key is turned to the Run position.
Sonic Boom (Optional)
The Sonic Boom switch is a rocker switch used to operate
the Sonic Boom. Toggle the switch forward for automatic,
rearward for manual and center for Off.
Foam Marker Switch Locations
(Optional)
If you install the Foam Marker kit, you will add switches to
the control panel for controlling their operation. The sprayer
comes with plastic plugs in these locations.
Regulating (Rate Control) Valve
(Figure
This valve, located behind the tank
amount of fluid that is routed to the booms or the rate return
to the tank.
1. Regulating (rate control)
valve
2. Agitation valve
3. Master boom valve
Master Boom Valve
The master boom valve
the flowmeter and boom valves.
Flowmeter
The flowmeter measures the flow rate of the fluid for use by
the InfoCenter system
Boom-Section Valves
These valves turn the three boom sections on or off
10).
20
(Figure 9), controls the
Figure 10
4. Flowmeter
5. Boom-section valves
(Figure 10) is used to stop the flow to
(Figure 10).
(Figure