Toro 41188 Operator's Manual page 50

5. Remove the boom and pivot bracket assembly from
the center frame to access the nylon bushings.
6. Remove and inspect the nylon bushings from the front
and back sides of the pivot bracket
Note: Replace any damaged bushings.
7. Place a small amount of oil on the nylon bushings and
install them into pivot bracket.
8. Install the boom and pivot bracket assembly into the
center frame, aligning the openings
9. Install the pivot pin and secure it with the bolt and nut
removed previously.
10. Repeat the procedure for each boom.
(Figure 43).
(Figure 43).
50