Toro 41188 Operator's Manual page 59

Installing the Rate Control Manifold
Valve
1. Align a 1 gasket between the flanges of the rate control
valve manifold and the pressure filter head (A of
61).
Note: If needed, loosen the mounting hardware for
the pressure filter head as needed to provide clearance.
Figure 61
1. Locknut 5. Gasket
2. Valve mount 6. Clamp
3. Flange 7. Flange
(agitation
valve)
4. Flanged-head 8. Flange (rate
bolt
2. Assemble the rate control valve manifold, gasket, and
pressure filter head with a clamp tightened hand tight
(A of Figure 61).
3. Align a 1 gasket between the flanges of the rate control
valve and the agitation valve manifold (A of
4. Assemble the rate control valve manifold, gasket, and
agitation valve manifold with a clamp tightened hand
tight (A of Figure 61).
9. Manifold valve
assembly
10. Socket (outlet
fitting)
11. Retainer
(pressure filter
head)
control valve)
Figure
5. Assemble the rate control valve to the valve mount with
the 2 flanged-head bolts and 2 flanged locknuts (A of
Figure 61) that you removed in step
Rate Control Manifold Valve (page 54)
Figure
nut and bolt to 1017 to 1243 N-cm (90 to 110 in-lb).
6. Assemble the outlet fitting onto the lower endcap
fitting of the manifold valve (B of
7. Secure the endcap fitting to the outlet fitting by
inserting a retainer into the socket of the outlet fitting
(B of Figure
8. If you loosened the mounting hardware for the
pressure filter head, tighten the nut and bolt to 1978 to
2542 N-cm (175 to 225 in-lb).
61)
59
3 of
Figure
61).
Removing the
and torque the
61).