Specifications - Toro GrandStand 74534TE Operator's Manual

1. Safety-interlock symbols
2. Battery light
Throttle Control
The throttle control is variable between Fast and Slow.
Choke
Use the choke to start a cold engine.
Blade-control Switch (PTO)
The blade-control switch (PTO) is used to engage the
electric clutch to drive the mower blades with the right side
motion-control lever in the center, unlocked position. Pull
the switch up to engage the blades and release. To disengage
the blades, push the blade-control switch (PTO) down or
move or release the right side motion-control lever into the
neutral-lock position.
Ignition Switch
This switch is used to start the mower engine and has three
positions: Off, Run and Start.
Motion-control Levers
The motion-control levers are used to drive the machine
forward, reverse, and turn either direction.
Fuel Shutoff Valve
Close the fuel shutoff valve (located behind the operator
cushion on the right hand side of fuel tank) when transporting
or storing the mower.
Attachments/Accessories
A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
Figure 6
3. Hour meter

Specifications

Note: Specifications and design are subject to change
without notice.
Model 74534TE
Cutting width
Width with deflector down
Length with platform down
Length with platform up
Height
Weight
Model 74536TE
Cutting width
Width with deflector down
Length with platform down
Length with platform up
Height
Weight
15
91 cm (36 inches)
131 cm (52 inches)
188 cm (74 inches)
155 cm (61 inches)
122 cm (48 inches)
343 kg (756 lb)
102 cm (40 inches)
142 cm (56 inches)
178 cm (70 inches)
145 cm (57 inches)
122 cm (48 inches)
351 kg (773 lb)