Belt Maintenance; Checking The Belts; Replacing The Mower-Deck Belt For 91 Cm Mowers - Toro GrandStand 74534TE Operator's Manual

Adjusting the Brakes
If the gap between the brake bar and tire is not correct, an
adjustment is required.
1. Park the machine on a level surface and disengage the
PTO, and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Release the parking brake; refer to
Parking Brake (page
4. To adjust the brake, remove clevis pin and hairpin-cotter
pin from the lower-brake lever and yoke
5. Adjust the yoke (Figure
Note: The distance between the brake bar and the tire
needs be between 3 and 6 mm (1/8 and 1/4 inches).
Note: To tighten the brake, rotate the yoke up.
Note: To loosen the brake, rotate the yoke down.
6. Check the brake operation again; refer to
Parking Brake (page
7. Secure the yoke to the lower-brake lever with the clevis
pin and hairpin-cotter pin
Figure 63
1. Yoke
2. Clevis pin
Releasing the
18).
(Figure
62).
Checking the
45).
(Figure 63).
g013291
3. Lower-brake lever
4. Hairpin-cotter pin

Belt Maintenance

Checking the Belts

Service Interval: Every 100 hours—Check the pump-drive
Every 100 hours—Check the mower-deck belt(s).
Check belts for cracks, frayed edges, burn marks, wear, signs
of overheating or any other damage.
The signs of a worn mower belt are squealing while the belt
63).
is rotating, blades slipping while you are cutting grass, frayed
belt edges, burn marks, and cracks. Replace the mower belt if
you detect any of these signs.
Replacing the Mower-Deck
Belt for 91 cm Mowers
Important: The fasteners on the covers of this machine
are designed to remain on the cover after removal.
Loosen all of the fasteners on each cover a few turns so
that the cover is loose but still attached, then go back
and loosen them until the cover comes free. This will
prevent you from accidentally stripping the bolts free
of the retainers.
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Loosen the bolts and remove the right belt cover with
the bolt attached to it.
4. Remove the spring from the anchor post on the
idler-pulley arm
5. Remove the worn mower belt
6. Install the new mower belt around the clutch pulley, the
deck pulleys, and the idler pulley
7. Install the spring onto the anchor post on the
idler-pulley arm
8. Install the belt cover onto the cutting unit and secure
the bolt.
46
belt.
(Figure 64).
(Figure 64).
(Figure 64
(Figure 64 ).
).