Using The Safety-Interlock System - Toro GrandStand 74534TE Operator's Manual

Stopping the Engine
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the tractor while it is
unattended.
Always remove the ignition key and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.
Let the engine idle at slow throttle (turtle) for 60 seconds
before turning the ignition switch off.
Figure 19
Important: Make sure the fuel shutoff valve is closed
before transporting or storing the machine, as fuel
leakage may occur. Before storing the machine, pull
wire off spark plug(s) to prevent possibility of accidental
starting.
Using the Safety-Interlock
System
CAUTION
If safety-interlock switches are disconnected or
damaged the machine could operate unexpectedly
causing personal injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock switches
daily and replace any damaged switches before
operating the machine.
Understanding the Safety-Interlock
System
The safety-interlock system is designed to prevent the mower
blades from rotating unless:
•
The right side motion-control lever is moved to the
center, unlocked position.
•
The blade-control switch (PTO) is pulled on.
The safety-interlock system is designed to stop the mower
blades if you move or release the right side motion-control
lever into the neutral-lock position.
The hour meter has symbols to notify the user when the
interlock component is in the correct position. When the
component is in the correct position, a triangle will light
up in the corresponding square.
1. Triangles light up when the interlock components are in the
correct position
21
Figure 20