Controls System Maintenance; Adjusting The Motion-Control Handle Positions - Toro GrandStand 74534TE Operator's Manual

Controls System
Maintenance
Adjusting the Motion-Control
Handle Positions
Adjusting the Right Motion-Control
Lever
If the motion-control levers do not align horizontally, adjust
the right side motion-control lever.
Note: Adjust the horizontal alignment before the front to
back alignment.
1. Disengage the PTO, move the right motion-control
lever to the neutral position, and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Push the right motion-control lever down out of the
neutral-locked position
4. Check if the right motion-control lever aligns
horizontally with the left motion-control lever
68).
Figure 68
1. Left motion-control lever
2. Right motion-control lever
in the neutral-locked
position
5. To adjust the right motion-control lever horizontally,
the cam needs to be adjusted.
6. Release the cushion from the rear of the machine.
7. Loosen the nut holding the cam
(Figure 68).
(Figure
3. Check the horizontal
alignment here
4. Right motion-control lever
(Figure 69).
1. Cam
8. Adjust the cam until it aligns with the left
motion-control lever and tighten the nut for the cam.
Note: Moving the cam clockwise (in the vertical
position) lowers the handle, while moving it
counterclockwise (in the vertical position) raises the
handle.
Important: Ensure that the flat portion of the
cam does not go above a vertical position (right or
left), or you may cause damage to the switch.
49
Figure 69
2. Nut