Storage; Cleaning And Storage - Toro GrandStand 74534TE Operator's Manual

Storage

Cleaning and Storage

1. Disengage the power take off (PTO), set the parking
brake, and turn the ignition key to off. Remove the key.
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially the
engine. Clean dirt and chaff from the outside of the
engine's cylinder head fins and blower housing.
Important: You can wash the machine with mild
detergent and water. Do not pressure wash the
machine. Avoid excessive use of water, especially
near the drive system and engine. Pressure
washing can force dirt and water into critical parts,
such as spindle bearings and electrical switches.
3. Check the brake; refer to
4. Service the air cleaner; refer to
Cleaner (page 34).
5. Grease the machine; refer to
6. Change the engine oil; refer to
Oil (page 36).
7. Check the tire pressure; refer to
Pressure (page 43).
8. For long-term storage:
A. Add stabilizer/conditioner additive to fuel in the
tank.
B. Run engine to distribute conditioned fuel through
the fuel system (5 minutes).
C. Stop engine, allow to cool and drain the fuel tank;
refer to Servicing the Fuel Tank in
Maintenance (page
it stops.
D. Restart engine and run until it stops. Repeat, on
Choke until engine will not restart.
E. Dispose of fuel properly. Recycle as per local
codes.
Note: Do not store stabilizer/conditioned
gasoline over 90 days.
9. Remove the spark plug(s) and check its condition; refer
to Servicing the Spark Plug in
(page 34). With the spark plug(s) removed from the
engine, pour two tablespoons of engine oil into the
spark plug hole. Now use the starter to crank the
engine and distribute the oil inside the cylinder. Install
the spark plug(s). Do not install the wire on the spark
plug(s).
10. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged or defective.
11. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
Servicing the Brake (page
Servicing the Air
Lubrication (page 32).
Changing the Engine
Checking the Tire
Fuel System
38), or operate engine until
Engine Maintenance
12. Store the machine in a clean, dry garage or storage area.
Remove the key from the ignition switch and keep it
in a memorable place. Cover the machine to protect
it and keep it clean.
45).
61