Servicing The Engine Fuel Filter; Fuel Pick-Up Tube Screen - Toro 30864 Operator's Manual

1. Water separator filter canister
3. Clean the area where the filter canister mounts.
4. Remove the filter canister and clean the mounting
surface.
5. Lubricate the gasket on the filter canister with clean oil.
6. Install the filter canister by hand until the gasket
contacts mounting surface, then rotate it an additional
1/2 turn.
7. Tighten the drain plug on the bottom of the filter
canister and close the vent on the top of the canister
mount.
Servicing the Engine Fuel
Filter
Service Interval: Every 400 hours
The engine fuel filter should be replaced after every 400
hours of operation.
1. Clean the area around the fuel filter head (Figure 32).
1. Fuel Filter head
2. Remove the filter and clean the filter head mounting
surface (Figure 32).
Figure 31
1
2
g021576
Figure 32
2. Fuel Filter
3. Lubricate the filter gasket with clean lubricating engine
oil. Refer to the Engine Operator's Manual, included
with the machine, for additional information.
4. Install the dry filter canister, by hand, until the gasket
contacts the filter head, then rotate it an additional
1/2 turn.
5. Start the engine and check for fuel leaks around the
filter head.

Fuel Pick-up Tube Screen

The fuel pick-up tube, located inside the fuel tank, is equipped
with a screen to help prevent debris from entering the fuel
system. Remove the fuel pick-up tube and clean screen as
required.
30