Engine Maintenance; Servicing The Air Cleaner; Servicing The Engine Oil And Filter - Toro 30864 Operator's Manual

Engine Maintenance

Servicing the Air Cleaner

Check the air cleaner body for damage which could cause an
air leak. Replace if damaged. Check the whole intake system
for leaks, damage or loose hose clamps.
Service the air cleaner filter only when the service indicator
(Figure 28) requires it. Changing the air filter before it is
necessary only increases the chance of dirt entering the engine
when the filter is removed.
Important: Be sure the cover is seated correctly and
seals with the air cleaner body.
1. Release the latches securing the air cleaner cover to the
air cleaner body (Figure 28).
1
2
Figure 28
1. Air cleaner cover
2. Air cleaner cover latch
2. Remove the cover from the air cleaner body. Before
removing the filter, use low pressure air (40 psi, clean
and dry) to help remove large accumulations of debris
packed between outside of the filter and the canister.
Avoid using high pressure air which could force
dirt through the filter into the intake tract.
This cleaning process prevents debris from migrating
into the intake when the filter is removed.
3. Remove and replace the filter (Figure 29).
Cleaning of the used element is not recommended due
to the possibility of damage to the filter media. Inspect
the new filter for shipping damage, checking the sealing
end of the filter and the body. Do not use a damaged
element. Insert the new filter by applying pressure to
the outer rim of the element to seat it in the canister.
Do not apply pressure to the flexible center of the
filter.
3
g021217
3. Air cleaner service
indicator
1
1. Air cleaner cover
2. Air cleaner filter
3. Air cleaner indicator
4. Clean the dirt ejection port located in the removable
cover. Remove the rubber outlet valve from the cover,
clean the cavity and replace the outlet valve.
5. Install the cover orienting the rubber outlet valve in a
downward position—between approximately 5:00 to
7:00 when viewed from the end.
6. Secure the latches.
Servicing the Engine Oil and
Filter
Service Interval: Every 250 hours
Change the oil and filter every 250 hours.
1. Remove the drain plug (Figure 30) and let the oil flow
into a drain pan. When all the oil is drained, install
the drain plug.
2
1. Engine oil drain plug
2. Remove the oil filter (Figure 30). Apply a light coat of
clean oil to the new filter seal before screwing it on.
Do not overtighten.
3. Add oil to the crankcase; refer to Checking the Engine
Oil.
28
2
g021218
Figure 29
g021890
1
Figure 30
2. Oil filter
3