Product Overview; Controls - Toro 30864 Operator's Manual

Product Overview

Controls

Seat Adjusting Knobs
The seat adjusting lever (Figure 4) allows you to adjust the
seat fore and aft. The weight adjusting knob adjusts the seat
for the operator's weight. The weight gauge indicates when
the seat is adjusted to the weight of the operator. The height
adjusting knob adjusts the seat for the operator's height.
1. Weight gauge
2. Weight adjusting knob
Traction Pedal
The traction pedal (Figure 5) controls the forward and reverse
operation. Press the top of the pedal to move forward and the
bottom to move rearward. Ground speed depends on how
far you press the pedal. For no load, maximum ground speed,
fully press the pedal while the throttle is in the Fast position.
To stop, reduce foot pressure on the traction pedal and allow
it to return to the center position.
Mow Speed Limiter
When the mow speed limiter (Figure 5) is flipped up it will
control the mow speed and allow the cutting decks to be
engaged. Each spacer adjusts the mowing speed by ½ mile
per hour. The more spacers you have, on the top of the bolt
the slower you will go. For transport, flip back the mow speed
limiter and you will have maximum transport speed.
Brake Pedal
Press the brake pedal (Figure 5) to stop the machine.
Parking Brake
To engage the parking brake, (Figure 5) push down on the
brake pedal and press the top forward to latch. To release the
parking brake, press the brake pedal until the parking brake
latch retracts.
Figure 4
3. Height adjusting knob
4. Adjusting lever (fore and
aft)
1. Traction pedal
2. Mow speed limiter
3. Spacers
Tilt Steering Pedal
To tilt the steering wheel towards you, press the foot pedal
(Figure 5) down, and pull the steering tower toward you to
the most comfortable position and then release the pedal.
Engine Speed Switch
The engine speed switch (Figure 6) has two modes to change
the engine speed. By momentarily tapping the switch, the
engine speed can be increased or decreased in 100 rpm
increments. By holding the switch down the engine will
automatically move to High or Low idle, depending on which
end of the switch is depressed.
2
1
3
4
5
6
1. Lower mow/raise control
lever
2. Key switch
3. InfoCenter
12
Figure 5
4. Brake pedal
5. Parking brake
6. Tilt steering pedal
Figure 6
4. Enable/disable switch
5. Engine speed switch
6. Headlight switch
G021208