Toro 30864 Operator's Manual page 15

Using the Menus
To access the InfoCenter menu system, press the menu access
button while at the main screen. This will bring you to the
main menu. Refer to the following tables for a synopsis of
the options available from the menus:
Main Menu
Menu Item
Faults
Service
Diagnostics
Settings
About
Service
Menu Item
Hours
Counts
Diagnostics
Menu Item
Cutting Units
Hi/Low Range
Description
The Faults menu contains
a list of the recent machine
faults. Refer to the Service
Manual or your Authorized Toro
Distributor for more information
on the Faults menu and the
information contained there.
The Service menu contains
information on the machine
such as hours of use, counters,
and other similar numbers.
The Diagnostics menu displays
the state of each machine
switch, sensor, and control
output. You can use this to
troubleshoot certain issues as
it will quickly tell you which
machine controls are on and
which are off.
The Settings menu allows
you to customize and modify
configuration variables on the
InfoCenter display.
The About menu lists the
model number, serial number,
and software version of your
machine.
Description
Lists the total number of hours
that the machine, engine and
PTO have been on, as well
as the number of hours the
machine has been transported
and service due.
Lists numerous counts the
machine has experienced.
Description
Indicates the inputs, qualifiers,
and outputs for raising and
lowering the cutting units.
Indicates the inputs, qualifiers,
and outputs for driving in
transport mode.
PTO
Engine Run
Settings
Menu Item
Units
Language
LCD Backlight
LCD Contrast
Protected Menus
Counterbalance
Auto Idle
* Only "operator-faced" text is translated. Faults, Service, and
Diagnostics screens are "service-faced". Titles will be in the
selected language, but menu items are in English.
About
Menu Item
Model
SN
Machine Controller Revision
InfoCenter Revision
CAN Bus
Protected Menus
There are 2 operating configuration settings that are adjustable
within the Settings Menu of the InfoCenter: auto idle time
delay and counterbalance. These settings can be locked by
using the Protected Menu.
Note: At the time of delivery, the initial password code is
programmed by your distributor.
15
Indicates the inputs, qualifiers,
and outputs for enabling the
PTO circuit.
Indicates the inputs, qualifiers,
and outputs for starting the
engine.
Description
Controls the units used on the
InfoCenter. The menu choices
are English or Metric
Controls the language used on
the InfoCenter*.
Controls the brightness of the
LCD display.
Controls the contrast of the
LCD display.
Allows the
superintendant/mechanic to
access protected menus by
inputting a passcode.
Controls the amount of
counterbalance applied to the
cutting decks.
Controls the amount of time
allowed before returning the
engine to low idle when the
machine is stationary.
Description
Lists the model number of the
machine.
Lists the serial number of the
machine.
Lists the software revision of
the master controller.
Lists the software revision of
the InfoCenter.
Lists the machine
communication bus status.