Table of Contents
Advertisement
1
2
4
Figure 62
1. Pivot pin
2. Bolt
3. Nut
4. Remove the boom and pivot bracket assembly from
the center frame to access the nylon bushings.
5. Remove and inspect the nylon bushings from the
front and back sides of the pivot bracket (Figure 62).
Replace any damaged bushings.
6. Place a small amount of oil on the nylon bushings
and install them into pivot bracket.
7. Install the boom and pivot bracket assembly into the
center frame, aligning the openings (Figure 62).
8. Install the pivot pin and secure it with the bolt and
nut removed previously.
Repeat the procedure for each boom.
4
5
3
G002017
4. Nylon bushing
5. Pivot bracket
Cleaning
Cleaning the Suction Strainer
Service Interval: Before each use or daily
1. Position the sprayer on a level surface, set the parking
brake, stop the pump, stop the engine, and remove
the ignition key.
2. Remove the retainer from the red fitting attached to
the large hose on the top of the tank (Figure 63).
1. Suction hose
3. Disconnect the hose from the tank (Figure 63).
4. Pull the suction strainer out of the hole (Figure 64).
1. Suction strainer
5. Clean the suction strainer with clean running water.
6. Replace the suction strainer, seating it fully into the
hole.
7. Connect the hose to the top of the tank and secure
it with the retainer.
53
Figure 63
2. Retainer
Figure 64
Advertisement
Table of Contents
