Table of Contents
Advertisement
1
Figure 36
1. Actuator
2. Actuator rod
3. Boom pivot pin housing
3. Lift up on the boom and remove the pin (Figure 36).
Slowly lower the boom to the hardstop.
4. Inspect the pin for any damage, replace if necessary.
5. Manipulate the actuator rod bearing end and apply
grease into the bearing (Figure 37). Wipe off excess
grease.
Figure 37
Right boom
1. Grease bearing
6. Lift up on the boom to align the pivot with the
actuator rod. While holding the boom, insert the
pin through both boom pivot and actuator rod
(Figure 36).
4
2
5
3
G002016
4. Cotter
5. Pin
7. With the pin in place, release the boom and secure
the pin with the cotter removed previously.
8. Repeat the procedure for each actuator rod bearing.
35
Advertisement
Table of Contents
