Table of Contents
Advertisement
Chemicals are hazardous and can cause
personal injury.
• Read the directions on the chemical labels
before handling the chemicals and follow
all manufacturer recommendations and
precautions.
• Keep chemicals away from your skin.
Should contact occur, wash the affected area
thoroughly with soap and clean water.
• Wear goggles and any other protective
equipment recommended by the chemical
manufacturer.
The Multi-Pro Sprayer has been specifically designed to
have high durability in order to give it the long sprayer
life you need. Different materials have been chosen for
specific reasons at different locations on your sprayer to
meet this goal. Unfortunately there is no single material
which is perfect for all foreseeable applications.
Some chemicals are more aggressive than others
and each chemical interacts differently with various
materials. Some consistencies (e.g. wettable powders,
charcoal) are more abrasive and lead to higher wear
rates. If a chemical is available in a formulation that
would provide increased life to the sprayer, use this
alternative formulation.
As always, remember to clean your sprayer thoroughly
after all applications. This will do the most to ensure
your sprayer has a long and trouble free life.
Filling the Fresh Water Tank
Always fill the fresh water tank with clean water before
handling or mixing any chemicals.
The fresh water tank is located at the rear, left side
of the chemical tank (Figure 19). It supplies a source
of fresh water for you to wash chemicals off of your
skin, eyes, or other surfaces in the case of accidental
exposure.
To open the fresh water tank spigot, turn the lever on
the spigot.
1. Fresh water tank
2. Filler cap
Filling the Spray Tank
Important: Ensure that the chemicals you will
be using are compatible for use with Viton (see
the manufacturer's label; it should indicate if it
is not compatible). Using a chemical that is not
compatible with Viton will degrade the O-rings in
the sprayer, causing leaks.
Important: The tank markings are for reference
only and cannot be considered accurate for
calibration.
1. Stop the sprayer on a level surface, move the range
selector to the Neutral position, stop the engine,
and set the parking brake.
2. Determine the amount of water needed to mix the
amount of chemical you need as prescribed by the
chemical manufacturer.
3. Open the tank cover on the spray tank.
The tank cover is located in the center of the top
of the tank. To open it, turn the front half of the
cover counterclockwise and swing it open. You
can remove the strainer inside for cleaning. To seal
the tank, close the cover and rotate the front half
clockwise.
4. Add 3/4 of the required water to the spray tank
using the anti-siphon fill receptacle.
Important: Always use fresh clean water in
the spray tank. Do not pour concentrate into
an empty tank.
24
Figure 19
3. Spigot
Advertisement
Table of Contents
