Installing The Seat; Installing The Seat Belt; Installing The Manual Tube - Toro 30344 Operator's Manual

1. Handle
3

Installing the Seat

Parts needed for this procedure:
Seat, Model 30398 and the Mechanical Seat
Suspension Kit, Model No. 30312 or the Pneumatic
1
Seat Suspension Kit, Model No. 30313 (obtained
separately)
Procedure
The Groundsmaster 3280-D is shipped without the
seat assembly. The optional Seat, Model 30398 and the
Mechanical Seat Suspension Kit, Model No. 30312 or
the Pneumatic Seat Suspension Kit, Model No. 30313
must be obtained and installed. Refer to the seat kit for
the installation instructions.
Note: An Auxiliary Power Unit Kit, Model No. 30382,
must be obtained and installed before installing a
Pneumatic Suspension Seat Kit to the machine.
Note: Refer to Installing the Manual Tube before the
seat is mounted to the seat suspension.
Figure 5
2. Hood cable bracket
4

Installing the Seat Belt

Parts needed for this procedure:
2 Seat belt
2 Bolts
2 Lock washer
2 Flat washer
Procedure
Install each end of the seat belt in the holes in the back
of the seat with 2 bolts (7/16 x 1 inch), flat washers
(7/16 inch), and lock washers (7/16 inch) (Figure 6).
Important: Mount the latch side of the belt to the
right side of the seat.
1. Seat belt latch
5

Installing the Manual Tube

Parts needed for this procedure:
1 Manual tube
2 R-clamp
Procedure
1. Remove the manual tube and R-clamps secured to
the seat plate. Discard the 2 mounting bolts and flat
washers.
16
Figure 6