Cooling System Maintenance; Cleaning The Radiator And The Screen - Toro 30344 Operator's Manual

4. Install the ball joint to the mounting bracket and
check the wheel toe-in.
5. After attaining desired adjustment, tighten the screw
on the tie rod clamp and secure the ball joint to the
mounting bracket.
Cooling System
Maintenance
Cleaning the Radiator and the
Screen
Service Interval: Every 200 hours
Every 1,500 hours
Every 1,500 hours
To prevent the engine from overheating, the screen and
radiator must be kept clean. Normally, check the screen
and radiator daily and, if necessary, clean any debris off
these parts. However, it will be necessary to check and
clean the screen and radiator frequently in extremely
dusty and dirty conditions.
Note: If engine shuts off due to overheating, first check
the radiator and screen for excessive buildup of debris.
Clean the radiator as follows:
1. Remove the screen.
2. Working from the fan side of the radiator, blow
with low pressure (25 psi) compressed air (do not
use water). Repeat the step from the front of the
radiator and again from the fan side.
3. After the radiator is thoroughly cleaned, clean out
debris that may have collected in the channel at the
radiator base.
4. Clean and install the screen.
49