Checking The Mower Deck Side-To-Side Height; Changing The Mower Deck Side-To-Side Height; Matching Height-Of-Cut - Toro 30071 Operator's Manual

Checking the Mower Deck
Side-to-Side Height
1. Adjust the rear tire pressure to specifications; refer to
Drive System Maintenance (page 26).
2. Position the blades side-to-side.
3. Measure at C and D locations from a level surface to
the cutting edge of blade tips (Figure 60).
4. The difference between measurements C and D should
be no more than 6 mm (1/4 inch).
Changing the Mower Deck
Side-to-Side Height
Changing the side-to-side height is done by adjusting the rear
tire pressure and caster spacers.
1. Change the rear tire pressure. Do this to the
corresponding side that needs adjustment.
2. Adjust the caster spacer.
3. Recheck the front-to-rear pitch and side to side leveling
of the cutting unit.

Matching Height-of-Cut

1. Check the rear tire pressure.
2. Set the height-of-cut to the 102 mm (4 inches) position
following the height-of-cut decal.
3. With the machine on level surface, position 1 blade
front-to-rear.
4. Measure at A and from level surface to the cutting edge
of the blade tips (Figure 61).
Figure 60
5. The measurement should be 102 mm (4 inches).
6. If it does not measure correctly:
A. Adjust the rear tire pressure.
B. Adjust the caster fork spacers.
C. Adjust the front mower deck support pins.
7. Check the carrier frame front-to-rear pitch.
41
Figure 61