1 2
Figure 14
1. Slot
Positioning the Flow Baffle
The following figures are only recommendations for use.
Adjustments will vary by grass type, moisture content, and
height of grass.
Note: If the engine power draws down and the mower
ground speed is the same, open up the baffle.
Position A
This is the full rear position (see Figure 15). The suggested
use for this position is a follows.
•
Use for short, light grass mowing conditions.
•
Use in dry conditions.
•
For smaller grass clippings.
•
Propels grass clippings farther away from the mower.
Figure 15
g012676
2. Nut
G012677
Position B
Use this position when bagging (Figure 16).
Position C
This is the full open position. The suggested use for this
position is as follows (Figure 17).
•
Use in tall, dense grass mowing conditions.
•
Use in wet conditions.
•
Lowers the engine power consumption.
•
Allows increased ground speed in heavy conditions.
18
G012678
Figure 16
G012679
Figure 17