Checking The Engine-Oil Level; Think Safety First; Operating The Parking Brake - Toro 30071 Operator's Manual

Commercial walk-behind mower 16hp, t-bar, hydro drive with 91cm turbo force cutting unit
Hide thumbs Also See for 30071:
Table of Contents

Advertisement

DANGER
In certain conditions during fueling, static
electricity can be released causing a spark which
can ignite the gasoline vapors. A fire or explosion
from gasoline can burn you and others and can
damage property.
• Always place gasoline containers on the ground
away from your vehicle before filling.
• Do not fill gasoline containers inside a vehicle or
on a truck or trailer bed because interior carpets
or plastic truck bed liners may insulate the
container and slow the loss of any static charge.
• When practical, remove gas-powered equipment
from the truck or trailer and refuel the equipment
with its wheels on the ground.
• If this is not possible, then refuel such
equipment on a truck or trailer from a portable
container, rather than from a gasoline dispenser
nozzle.
• If a gasoline dispenser nozzle must be used,
keep the nozzle in contact with the rim of the
fuel tank or container opening at all times until
fueling is complete.
WARNING
Gasoline is harmful or fatal if swallowed. Long-term
exposure to vapors can cause serious injury and
illness.
• Avoid prolonged breathing of vapors.
• Keep face away from nozzle and gas tank or
conditioner opening.
• Keep gas away from eyes and skin.
Using Stabilizer/Conditioner
Use a fuel stabilizer/conditioner in the machine to provide
the following benefits:
Keeps gasoline fresh during storage of 90 days or less.
For longer storage it is recommended that the fuel tank
be drained.
Cleans the engine while it runs
Eliminates gum-like varnish buildup in the fuel system,
which causes hard starting
Important: Do not use fuel additives containing
methanol or ethanol.
Add the correct amount of gas stabilizer/conditioner to the
gas.
Note: A fuel stabilizer/conditioner is most effective when
mixed with fresh gasoline. To minimize the chance of varnish
deposits in the fuel system, use fuel stabilizer at all times.
Filling the Fuel Tank
1. Shut the engine off and set the parking brake.
2. Clean around each fuel tank cap and remove the cap.
3. Add unleaded regular gasoline to both fuel tanks, until
the level is 6 to 13 mm (1/4 to 1/2 inch) below the
bottom of the filler neck.
This space in the tank allows gasoline to expand. Do
not fill the fuel tanks completely full.
4. Install fuel tank caps securely.
5. Wipe up any gasoline that may have spilled.

Checking the Engine-Oil Level

Before you start the engine and use the machine, check the oil
level in the engine crankcase; refer to Checking Oil Level in
Engine Maintenance (page 21).
Note: Determine the left and right sides of the machine
from the normal operating position.

Think Safety First

Carefully read all the safety instructions and decals in the
safety section. Knowing this information could help you or
any bystanders avoid injury.
The use of protective equipment for eyes, hearing, feet, and
head is recommended.
CAUTION
This machine produces sound levels in excess of
85 dBA at the operator's ear and can cause hearing
loss through extended periods of exposure.
Wear hearing protection when operating this
machine.

Operating the Parking Brake

Always set the parking brake when you stop the machine or
leave it unattended. Before each use, check the parking brake
for proper operation.
If the parking brake does not hold securely, adjust it. Refer to
Servicing the Brakes (page 29).
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while it is
unattended.
Always remove the ignition key and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.
12

Advertisement

Table of Contents
loading

Table of Contents