Initially Field-Testing The System - Toro Pro Control XP Operator's Manual

Spray system multi-pro 5800 turf sprayer
Table of Contents

Advertisement

Initially Field-testing the
System
Before operating the spray system, perform this
procedure.
1. Drive the vehicle at the desired spraying speed with
the sprayer booms off.
2. Press the [Speed] key to verify the speed readout.
3. Turn the Spray pump control switch to On.
4. Turn the Pro Control XP Power switch to the On
position.
5. Turn the Foot switch to the On position.
Note: Use the Foot switch when all the booms are
to be turned on.
6. Ensure that the Boom 1, Boom 2, and Boom 3
switches are in the On position.
7. Set the Man/Rate switch to Rate 1.
8. Increase or decrease the vehicle speed by 1 mph (2
km/h).
Note: The system should automatically correct
the target application rate. If the system does not
correct the application rate, review the Initial System
Setup; then refer to Troubleshooting.
9. After spraying a swath, switch the foot switch to the
Off position to shut off the spray flow to all booms.
Note: This also shuts off the area calculations.
10. Verify the area covered and the volume of material
sprayed.
13

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Pro Control XP and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

41604Pro control xp 41604

Table of Contents