Appendices; Troubleshooting - Christie E Series User Manual

5.

APPENDICES

5.1

Troubleshooting

If you experience a problem with your projector, please refer to the following
information. If a problem persists, please contact your local reseller or service
center.
No image appears on-screen

-
Make sure all the cables and power connections are correctly and
securely connected as described in the
-
Check if the projection lamp has been securely installed.
-
Make sure you have removed the lens cap and the projector is
switched ON.
Partial, scrolling or incorrectly displayed image

-
Press
-
If you are using a PC (for Windows 95, 98, 2000, XP, Windows 7):




E Series User Manual
020-000287-01 Rev. 1 (01-2011)
AUTO on control panel or on remote control.
" "
Open the My Computer
"
double click on the
Select the Settings
"
Verify that your display resolution setting is lower than or equal to
WUXGA (1920 × 1200).
Click on the Advanced Properties
"
not projecting the whole image, you will also need to change the
monitor display you are using. Refer to the following steps:
Verify the resolution setting is lower than or equal to WUXGA

(1920 × 1200).
Select the Change
"

Click on Show all devices
"

types under the SP box; choose the resolution mode you need
"
under the Models
"
Verify that the resolution setting of the monitor display is lower

than or equal to WUXGA (1920 × 1200).
Installation
"
icon, the Control Panel
" "
Display icon.
" "
tab.
"
button. If the projector is still
"
button under the
"
. Next, select
"
box.
"
Section 5: Appendices
section.
"
folder, and then
"
Monitor tab.
" "
Standard monitor
"
5-1