Operating Instructions - PowerWasher RN2600 Operation Manual

NOTE: The pump on this unit is
maintenance free and requires no oil,
If there is a problem with the pump
contact an Authorized Service Center.

OPERATING INSTRUCTIONS

Compare the illustrations with your unit to familiarize yourself with the location of
various controls and adjustments. Save this manual for future reference.
Spray
Gun
High
Pressure
Hose
Multi-Adjustable
Spray Wand
BASIC ELEMENTS OF A
PRESSURE WASHER
High Pressure Pump: Increases the
pressure of the water supply.
Engine: Drives the high pressure
pump. Refer to the engine manual
for location and operation of engine
controls.
High Pressure Hose: Carries the pres-
surized water from the pump to the
gun and spray wand.
gauge to check the tires pressure
before each use and while inflating
tires; see the tire sidewall for the
correct tire pressure.
NOTE: Air tanks, compressors and simi-
lar equipment used to inflate tires can fill
small tires similar to these very rapidly.
Adjust pressure regulator on air supply to
no more than the rating of the tire pres-
sure. Add air in small increments and
frequently use the tire gauge to prevent
over inflation.
Engine
Spray Gun: Connects with spray wand
to control water flow rate, direction,
and pressure.
Multi-Adjustable Spray Wand: Allows
the user to use high or low pressure and
adjusts from a pencil stream (0°) to a wide
angle fan spray (40°). See How To Use Wand
instructions in this section.
Chemical Hose (not shown): Feeds
cleaning agents into the pump to mix
with the water. See How To Apply
Chemicals/Cleaning Solvents instruc-
tions in this section.
9- ENG
Risk of bursting.
Use a tire pressure
High Pressure Pump